Scania Citywide GN14
Startup
To start the bus you need to press "E" to increment the position of the key. Press "M" to decrement.
Position 0: Remove key
Position 1: Insert key / shut off electrics
Position 2: Start electrics / stop engine
Position 3: Ignition on
Position 4: Start engine, hold "E"
CAUTION!
If the engine is on high idle speed due to cold temperature or activated by the high idle switch, start with caution. Due to the high RPM the torque converter is very strong on idle speed. It is recommended that you wait until the RPM reaches the normal state.
Door control
All three doors are manually controllable. The third door can be controlled automatically as well.
Third door manual: Door clearance switch, ( - ) key on the numpad
Third door automatic: 20h-switch, Roll-Key on the keyboard
1 Status indicators
2 Driver's information display
3 Display control and brightness selector (+/-)
4 Engine high idle speed switch
5 (Quit-key. Doesn't exist anymore)
Right arrow to confirm a selection
7 Manual kneeling
8 Reject kneeling
9 Increase/decrease height of the bus
Modes will be successively switched
10 Door wing lock
11 Door clearance for third door
This activates automatic door operation
12 Gear selectors
13 Stop request reset
Third door button controls third door manually
1 Driver's cab lighting
2 Cabin lights
Seperate control for trailer and front end. High and low mode selectable
3 Climate control
Sets temperature automatically to 20 °C
4 Disable traction control
5 Lights check
Press again to disable
6 Articulation overbend protection override
7 Fuel heating (No function)
8 Foglights control
9 Windscreen washing
10 Light switch
11 Hazard lights
1 Temp control for driver's cab
2 Air fan control for driver's cab
3 Air flow control for driver's cab
4 Door heater
5 Dehumidifier
6 Pre-heating
Only on stopped engine
7 Floor heater on entry
8 Dashboard unclamp (No function)
9 Microphone switch
10 Alarm LAT (No function)
11 Switch key for video surveillance monitor (No function)
12 Reset for door emergency handle
After pulling a door emergency handle you need to pull it again and then press this button to repressurize the door
13 Parking brake
14 Rooflights control unit
15 Outside door lighting
16 Automatic hazard light mode
17 Mirror heater
Driver's Information Display
The driver's information display can be controlled with the display page change switch (3) and the arrow keys (6). When driving you can only use the page change switch (3). It can cancel messages and shows pressure and fuel status. The arrow keys can only be used when standing still, engine stopped and ignition switched on. Press "i" to call the main menu. With the arrow keys you can select a menu.
Up: Recall warnings
Down: Open settings
Right: Show status pages or confirm a selection
Atron-Printer
C - Cancel/Exit
Arrow up - Next bus stop
Arrow down - previous bus stop
Enter - Confirm
After starting the electrics you need to enter your ID and PIN code.
ID: 9691
PIN: 1805